Combi 8000 Series instruction manual Stroller or Travel System Use, Operation and Adjustment

21

Section 10 - Stroller or Travel System Use

This infant car seat can only be used with COMBI stroller models to transport your infant.

Check COMBI stroller information or the COMBI International website at www.combi-intl.com, for an updated list of stroller models.

See stroller instructions for securing car seat and use information.

Section 11 - Operation and Adjustment

Changing Harness Use Position

Shoulder harness straps must be through slots at or just below shoulder.

To change shoulder belt slots:	Harness
	Safety
1. Buckle harness and chest clip.
	Cover

2.From front of car seat, loosen harness straps by pressing harness adjuster lever and pulling harness straps out to lengthen them.

3.From back of car seat, rotate harness safety cover out, unhook both harness

strap metal clips from adjuster loop (fig. a).

4.From front of car seat, pull harness straps out through car seat shell, seat pad and infant insert.

To Re-secure Harness Belts:

WARNING

•Shoulder belts MUST be through belt slots in infant insert.

•Do not use infant insert with top slots in car seat.

1.From front of car seat, rethread harness straps through desired harness strap

slots of infant insert, seat pad and seat back.

NOTE: Only use two lowest sets of shoulder belt slots with infant insert.

2. From back of car seat, route shoulder belts between plastic seat and metal rod. Pull harness straps down and re-attach harness strap metal clips to adjuster loop as shown in fig. c. Make sure harness straps are not twisted and are threaded through matching slot of seat pad and seat back.

3. Close harness safety cover, snap onto metal rod. 22	Metal
	Rod

(fig. a)

Harness

Strap Metal

Clip

Adjuster

Loop

Adjuster Strap Loop

(fig. c)