Combi 9850, 9810, 9800 Using the Reclining Backrest, Using and Adjusting the 5-Point Harness

Models: 9800

1 8
Download 8 pages 17.28 Kb
Page 4
Image 4
Using the Reclining Backrest

Using the Reclining Backrest

Use the high chair with the backrest in the full recline position to carry 2-3 month old babies without a strong neck.

The backrest can be adjusted to 5 positions.

The footrest angle changes along with the recline.

1.To recline the backrest, pull and hold the reclining lock lever

located on the back of the seat.

2.After the recline position is determined, always lock the reclining lock lever by releasing it to its original position.

To return the backrest to the upright position, pull and hold the reclining lock lever and push the seat forward. The seat will lock into place again by releasing the reclining lock lever.

Reclining Lock

Lever

CAUTION

Always adjust the harness when changing the reclining angle.

Always keep the reclining lock lever in the lock position.

Be careful that there are no obstacles in front of it before using since the footrest will move during the recline.

Full

1

upright

2

3 4

5

Full recline

Using and Adjusting the 5-Point Harness

WARNING

1. Place the crotch belt between the

Avoid serious injury

from falling or sliding

child's legs.

out. Always use har-

2. Insert both waist belt buckles into the

ness for security.

middle

 

plastic piece.

CAUTION

3. Attach each shoulder

Even when the har-

strap hooks to the top of

ness is fastened, be

the waist belt clips.

careful not to let

 

4. To adjust the harness or

the child slip out or

waist belt, loosen the

stand.

slack on both sides of

 

each buckle.

 

CAUTION

Attaching & Using the Wheels

Front Swivel Wheels Insert the swivel wheels, with the circular shaft, into the circular hole in the base of the front legs.

Always keep the wheels locked other than when moving the high chair. Failure to do so may cause the high chair to move unexpectedly.

Wheels must be locked when using the glide feature.

Rear Stationary Wheels Insert the rear wheels, with the square shaft, into the square hole in the base of the rear legs.

To lock wheels, lower the brake lever. (Down position.)

To unlock wheels, lift the brake lever. (Up position.)

Brake Lever

- 4 -

Page 4
Image 4
Combi 9850, 9810, 9800 Using the Reclining Backrest, Using and Adjusting the 5-Point Harness, Attaching & Using the Wheels