3INSTALLATION AND CONNECTION
On the back of the monitor three kinds of plug-in connec- tions are provided: AC power connector for the AC input, two DB9-15P connectors for video signal input, and USB ports for USB communication.
3.1AC Power Connection
One end of the AC power cord is connected to the AC power connector on the back of the monitor. The other end is plugged into a properly grounded three-prong AC outlet. The monitor’s auto-sensing power supply can automati- cally detect 100-120V AC or 220-240V AC and 50 or 60Hz.
3.2Signal Cable Connection
The DB9-15P(VGA) connector is provided for compatible analog RGB outputs from your computer.
3.2.1 Connection to VGA Compatible System
Figure 5 shows the SC-B110 cable connection to the Video Graphics Array (VGA) port.
1.Power off, both the monitor and the computer.
2.Connect the one end of the SC-B110 cable to the DB9-15P connector on the VGA controller card.
3.Connect the other end of the SC-B110 cable to the DB9-15P receptacle on the back of the monitor.
4.Power on the monitor, then the computer.
5.After using the system, power off the monitor, then the computer.
Figure 5
The socket-outlet shall be installed near the equipment and shall be easily accessible. During servicing, discon- nect the plug from the socket-outlet.
