Compaq 3134 manual Attaching the Upgrade Module, Removing the Adapter from a Server

2-2Compaq NC3134 Fast Ethernet Server Adapter User Guide

Attaching the Upgrade Module

The Compaq NC3134 Fast Ethernet Server Adapter design lets you attach an upgrade module. This increases the number of RJ-45 ports to four, in addition to adding one 100 Mb/s FX fiber port, one 1000 Mb/s fiber port, or one RJ-45 port that delivers 1000 Mb/s over twisted-pair (Gigabit over copper) cabling.

A Compaq Fast Ethernet or Gigabit upgrade module comes factory-assembled with a plastic extension bracket (clamp) installed on the module. A kit packaged with each upgrade module contains the following parts to attach the module to the adapter:

■Two rivet assemblies — two hollow rivets and two flat-headed rivet pins

■Read This First card — Instructions for attaching the upgrade module

Removing the Adapter from a Server

If the adapter is already installed in a Compaq ProLiant server, you must first remove it to install the upgrade module. If the adapter is not installed, go to the section titled “Installing the Upgrade Module on the Adapter.”

NOTE: See the Compaq ProLiant PCI Hot Plug documentation for general information on removing the adapter.

1.If the server is not PCI Hot Plug compliant, power down the server and unplug the power cord.

2.Remove the server’s cover.

WARNING: To reduce the risk of personal injury from hot surfaces, allow the internal system components to cool before touching them.

CAUTION: If the server is not PCI Hot Plug compliant, power it down and unplug the power cord from the power outlet before removing the server cover. Failure to do so may damage the adapter or server.

3.Remove the screw or clip holding the adapter in the server, then slide the adapter out of the PCI slot.

Installing the Upgrade Module on the Adapter

Follow these steps to install the upgrade module. Refer to Figure 2-1 for more information.

1.Remove any adhesive strip (provided for safety) that is sealing the option door on the adapter.

2.Push and hold open the spring-loaded option door on the adapter.

3.Align the ports on the upgrade module with the option door opening, the two board-to- board connectors on the upgrade module with the two board-to-board connectors on the adapter, as well as the standoff (not included on all boards) on the upgrade module with the hole in the adapter.

4.Gently but firmly press the connectors and the standoff (not included on all boards) together until they are securely seated in each board.