Compaq 5700 manual Precautions for Products with Laser Devices

■Do not plug a modem or telephone cable into the Network Interface Card (NIC) receptacle.

■Disconnect the modem cable before opening a product enclosure, touching or installing internal components, or touching an uninsulated modem cable or jack.

■Do not use a telephone line to report a gas leak while you are in the vicinity of the leak.

Precautions for Products with Laser Devices

In addition to the general precautions described earlier in this section, be sure to observe the following precautions when operating a product equipped with a laser device. Failure to observe these precautions could result in fire, bodily injury, and damage to the equipment.

■Do not operate controls, make adjustments, or perform procedures to a laser device other than those specified herein or in the CD-ROM drive installation guide.

■Allow only Compaq-authorized service technicians to repair the laser equipment.

■All Compaq systems equipped with CD-ROM drives comply with appropriate safety standard including IEC 825. With specific regard to the laser, the equipment complies with laser product performance standards set by government agencies as a Class 1 laser product. It does not emit hazardous light; the beam is totally enclosed during all modes of customer operation and maintenance.

This system is classified as a CLASS 1 LASER PRODUCT. This label is located on the outside of your system. A similar label also appears on the internal CD-ROM installed in your system.

User’s Guide 5