5.Use the provided Phillips screwdriver to remove the screw 4 from the lamp cover.
6.Remove the cover 5.
7.On the left side of the lamp module, push the electrical connector 6 up to disengage it from the projector base.
8.Remove the three screws 7 from the lamp module.
9.Pull out the lamp module 8.
WARNING: To reduce the risk of personal injury, do not
! drop the lamp module or touch the glass bulb. The glass may shatter and cause an injury if it is dropped.
To replace the lamp module, reverse the previous steps.
✎After replacing the lamp module, remember to reset the lamp hours in the
IMPORTANT: This lamp contains < 0.125 percent mercury by weight. If the projection lamp breaks, the mercury may be released into the atmosphere. Please follow applicable federal, state, and local regulations for disposal and/or recycling.