Figure 3 Installation Warning Message

5.2USB-CDC Setup6.0Specifications6.1Power requirement6.2Physical housing uSign 100Manual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgrounduSignManual backgroundUserManual backgroundManualManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual background

There is a warning window that the INF file is not registered; Click “Continue Anyway”. Click Finish to complete the INF installation.

Figure 3 Installation Warning Message

5.2USB-CDC Setup

The following steps provide a check on the USB-CDC COM port selected by the operating system. This step is used only if there is a need to confirm operation and possible to review the communication port number. Open the Windows Control Panel and follow the selections: System, Hardware Tab, and Device Manager. Expand the Port (COM & LPT) folder. There should be an item “IDTECH USB-RS232 uSign (COM #)”, where # is a Port number. uSign is set-up and communicating.

6.0Specifications

6.1Power requirement

Voltage

uSign 100 is 9VDC and uSign 200 is 5VDC

Current

150mA typical

RS232 Power

AC adapter, center positive adaptor plug output

USB Power

Host USB port

6.2Physical housing uSign 100

Overall size

113mm wide

 

77.5mm high

 

31.5mm thick including back plate

Display

3.3-inch diagonal signature area

Copyright © 2006, International Technologies & Systems Corp. All rights reserved.

Page 10 of 18

Page 10
Image 10
Compaq uSign 200 Specifications, USB-CDC Setup, Power requirement, Physical housing uSign, Installation Warning Message