|
|
| uSign User Manual |
|
|
|
| ||
Table of Contents |
| |||
1.0 | Introduction | 6 | ||
2.0 | Features | 6 | ||
3.0 | Model Designations | 7 | ||
4.0 | Installing uSign | 7 | ||
4.1 | Communication Interface | 8 | ||
4.2 | 10 | |||
5.0 | Terms & Abbreviations | 7 | ||
6.0 | Specifications | 10 | ||
6.1 | Power requirement | 10 | ||
6.2 | Physical housing uSign 100 | 10 | ||
6.3 | Physical housing uSign 200 | 11 | ||
6.4 | LCD screen & Resistive touch pad | 11 | ||
6.5 | Communication interface | 11 | ||
6.6 | LED | ....................................................................................................... | 11 | |
6.7 | Agency Approvals | 11 | ||
6.8 | Electronics MTBF | 11 | ||
6.9 | 11 | |||
6.10 | Environmental | 11 | ||
7.0 | uSign commands description | 13 | ||
7.1 | Command protocol: | 13 | ||
7.2 | System Commands | 13 | ||
7.2.1 | Get firmware version | 13 | ||
7.2.2 | Get serial number | 13 | ||
7.2.3 | Get clip area | 13 | ||
7.2.4 | Set clip area | 13 | ||
7.2.5 | Clear clip area | 13 | ||
7.3 | One byte commands | 14 | ||
7.3.1 | Stop Capturing | 14 | ||
7.3.2 | Start Capturing use FBP format 1 | 14 | ||
7.3.3 | Start Capturing use FBP format 2 | 14 | ||
7.3.4 | Turn red led on | 14 | ||
7.3.5 | Turn red led off | 14 | ||
7.3.6 | Clear CMP format mode data | 14 | ||
7.3.7 | Get data 0x00 | 14 | ||
7.3.8 | Start Capturing use CMP format | 14 | ||
7.3.9 | Reset points counter | 14 | ||
7.3.10 | Get point counter high byte | 14 | ||
7.3.11 | Get point counter low byte | 14 | ||
7.3.12 | Start Capturing use FBP format 0 | 15 | ||
7.4 | 15 | |||
7.4.1 | Initialize device | 15 | ||
7.4.2 | Get PW120 Version | 15 | ||
7.4.3 | Test device | 15 | ||
7.4.4 | Set CTS control | 15 | ||
7.4.5 | Set interval between two points | 15 | ||
Copyright © 2006, International Technologies & Systems Corp. All rights reserved.
Page 4 of 18
