Compatible Systems 2270R manual PPP Configuration, Internal T1 CSU/DSU WAN 0 Link Configuration

Chapter 6 - Basic Configuration Guide 23

PPP Configuration

This section covers the settings required for PPP (point-to-point) protocol operation of the WAN interfaces.

Internal T1 CSU/DSU (WAN 0) Link Configuration

Required for Dedicated Line Operation

This is the only mode of operation supported via the built-in T1 CSU/DSU.

•Set PPP connection

CV: Use the Link Configuration: WAN 0 Dialog Box.

TB: Use configure and set the Mode keyword in the Link Config WAN 0 section.

Suggested for Dedicated/Leased Line Operation

Dedicated line operation generally does not require additional parame- ters for operation.

RS-232 (WAN 1) Link Configuration

Required for Dedicated/Leased Line Operation

Dedicated line operation is the simplest to set up.

•Set Dedicated connection

•Set PPP connection

CV: Use the Link Configuration: WAN 1 Dialog Box.

TB: Use configure and set the Mode and ConnectMode keywords in the Link Config WAN 1 section.

Suggested for Dedicated/Leased Line Operation

Dedicated line operation generally does not require additional parame- ters for operation.

Required for Dial-On-Demand Operation

This mode of operation is only supported on the WAN 1 RS-232 inter- face. Incoming dial-on-demand operation requires only slightly more information than dedicated line setup. Outgoing dial-on-demand requires additional information (see the suggested settings below).

•Set dial-up connection

•Set PPP connection