22 Chapter 6 - Basic Configuration Guide
Configuration Using CompatiView
This section provides a list of parameters that must be entered into a
server for proper operation using CompatiView, Compatible Systems’
management software. If you wish to use the command line interface to
configure the server, see the next section in this chapter, Basic Configu-
ration Using Command Line.

VPN Client Tunnel Settings

Configuration of the server for both dual and single Ethernet setups is
very similar, but when there are differences between them, the appro-
priate step for each setup is indicated.
v Note: Remember that in single Ethernet setups, Ethernet 1 must not
be connected to anything or else it may cause difficult to diagnose
problems on the IntraPort 2/2+ and on your netwo r k .
1. Turn off AppleTalk and IPX (optional).
If you are using AppleTalk and/or IPX, you can either leave the default
configuration parameters in place or see Chapter 7 for more information
on configuring those protocols. If you are not using AppleTalk and/or
IPX:
A. Click on the AppleTalk Routing protocol branch under E ther-
net 0. In the AppleTalk Routing dialog box select the Phase 2
Off radio button.
B. Click on the IPX Routing protocol branch under Ethernet 0. In
the IPX Routing dialog box selec t the IPX Off radio button
C. Click OK.