IMPORTANT
SAFETY
INSTRUCTIONS
WHEN USING ELECTRICAL APPLIANCES, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED, INCLUDING THE FOLLOWING:
READ ALL INSTRUCTIONS BEFORE
USING THIS MIRROR
DANGER– TO REDUCE THE RISK OF ELECTRIC SHOCK: ALWAYS UNPLUG THIS mirror
FROM THE ELECTRICAL OUTLET BEFORE CLEANING. WARNING– TO REDUCE THE RISK OF BURNS, ELECTROCUTION, FIRE, OR INJURY
TO PERSONS:
1.Unplug from outlet before putting on or taking off parts.
2.This mirror should not be used by or near children or individuals with certain disabilities.
3.Use this mirror only for its intended use as described in these instructions. Do not use attachments not recommended by the manufacturer.
4.Never operate this mirror if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or dropped into water. Return the mirror to a service center for examination and repair.
5.Keep the cord away from heated surfaces.
6.Never drop or insert an object into any opening.
7.Do not use outdoors.
8.Do not operate where aerosol (spray) products are being used or where oxygen is being administered.
9.To disconnect, turn all controls to the off position, then remove plug from outlet.
10.Be sure mirror is not in a position where it can reflect sunlight; reflected sunlight can cause fire.
11.Do not use on a soft surface such as a bed, where openings may be blocked.
12.Turn switch to off position and unplug cord before replacing light bulbs.
13.Do not place or store mirror where it can fall or be pulled into a tub or sink.
14.If mirror falls into water, unplug it immediately. Do not reach into the water.
15.Never use while sleeping.
16.Do not use bulb greater than 20 watts. Use in any 120 volt, 60 hertz AC electric outlet (ordinary house current). Do not use it in any other electrical outlet.
17.To protect against electrical hazards, do not use while bathing or in the shower.
18.Unplug the mirror from outlet before cleaning. Do not leave mirror unattended when it is plugged in.
FOR HOUSEHOLD USE ONLY
SAVE THESE
INSTRUCTIONS
OPERATING
INSTRUCTIONS
To reduce the risk of electric shock, this mirror has a polarized plug (one blade is wider than the other). This plug will fit into a polarized outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet.
Do not change the plug in any way.
1.Your lighted makeup mirror will swivel so that you can use either the normal, flat mirror or the magnifying mirror located on the opposite side.
2.Plug cord into any standard 120 volt wall outlet. To turn on lights, simply turn the dial on the base to desired light setting.
3.After use, always turn switch to the off position.
4.The beauty and design of the Classique™ Collection mirror complement any decor. Therefore, you may wish to leave the mirror displayed. However, if you choose to store the mirror, see STORAGE, below, for detailed information.
SPECIAL FEATURES
This lighted makeup mirror uses incandescent light bulbs with special coating, reproducing
TO Replace Bulb
CAUTION: TURN OFF POWER AND UNPLUG. ALLOW TO COOL AT LEAST 3 MINUTES BEFORE REPLACING BULB.
NOTE: Do not use a bulb greater than 20 watts. Contact a Conair service center at
1.Remove screws from top and bottom of mirror (Fig. 1).
2.Carefully lift off the removable housing from the half that is affixed to the stand.
3.Unscrew the old bulb and replace with the
new bulb (Fig. 2).
4.Carefully replace the removable half after locating and aligning the screw holes to the fixed half.
5.Insert screws into screw holes and tighten.
Figure 1
Figure 2
