Cooper Lighting ADY071464 installation instructions Small, INDOOR P1R, Visor and Non-Visor

Installation Instructions

Sheet 1 of 2

Vault C-Scroll Roundel

These installation instructions are valid with the above Ametrix styles.

Small, INDOOR

P1R

(Pendant, 1-way, Remote ballast)

Visor and Non-Visor

Warning: Before starting any work ensure that all sources of power are turned off. All work must meet local/national codes and be performed by a certified electrician. Do not mount fixtures vertically.

Exploded view and part call-out

1Mounting the fixture

J-box
(by others)
	#10-32 x3/8"
	Set screw(2x)
1/4" fasteners
(by others)	Wiring holes
Fixture	Canopy
head

1/4" fasteners (by others) (4x)

Use additional bracing

around J-box to support fixture.

#10-32 x3/8" Set screw(2x)

Canopy

Yoke

#10-32 x5/8" End screw (x2)

#10-32 x5/8" End screw (2x)

1.Using both #10-32 x5/8" end screws, secure fixture head to yoke on pendant and run fixture wire through pendant.

2.Remove both #10-32 x3/8" set screws and allow canopy to slide down pendant.

3.Run wires from pendant and j-box through wiring holes in mounting plate.

4.Using appropriate fasteners, secure fixture to ceiling. Use additional bracing around J-box to support fixture.

2Wiring the fixture

#10-32 x3/8" Set screw (2x)

1.After securing fixture to ceiling, attach appropriate wires and ensure all connections are properly matched.

2.Push wire connections into j-box and cover mounting plate with canopy.

3.Secure canopy using both #10-32x 3/8" set screws.

3Aiming the fixture

Fixture head

indicatorYoke arm indicator

#10-32 x5/8" End screw (2x)

1.To aim fixture, loosen both #10-32 x5/8" end screws. When both indicators are lined up, the slope of the lens face is 40- degrees. Each subsequent notch is an additional +/- 10- degrees

2.When fixture head is rotated to desired angle, retighten end screws to secure the position.

ADY071464 REV B (ECN80481)