Bosch Appliances LTC 2210 1.0UNPACKING, 2.0SERVICE, 3.0DESCRIPTION, 4.0INSTALLATION, 4.1Power, En

LTC 2210 Series Instruction Manual Unpacking EN 6

1.0UNPACKING

This equipment should be unpacked and handled with care. If an item appears to have been damaged in shipment, notify the shipper.

Verify that all parts shown in the Parts List have been included. If any items are missing, notify your Bosch Security Systems Sales or Customer Service Representative.

The original packing carton is the safest container in which to transport the unit. Save it for possible future use.

1.1Parts List

Qty Item

1Unit (verify model number)

1One (1) 15-pin cable assembly

2.0SERVICE

If the unit needs repair, contact the nearest Bosch Security Systems Service Center for authorization to return and shipping instructions.

Service Centers

USA

Phone: 800-366-2283 or 717-735-6638 Fax: 800-366-1329 or 717-735-6639

CCTV Spare Parts

Phone: 800-894-5215 or 408-956-3853 or 3854 Fax: 408-957-3198

E-mail: BoschCCTVparts@ca.slr.com Canada

Phone: 514-738-2434

Europe, Middle East & Asia Pacific Region Phone: 32-1-440-0711

For additional information, see www.boschsecurity.com.

3.0DESCRIPTION

The LTC 2210 Series video motion detectors utilize edge detection with digital tracing technology. Patented circuitry provides reliable security surveillance protection. These economical, full featured single channel detectors provide flexible operation to maximize performance and minimize false alarms.

Motion is detected over the full active video for NTSC, PAL and SECAM.

4.0INSTALLATION

4.1Power

Model	LTC2210/60	LTC 2210/50
Rated Voltage	120 VAC, 50/60 Hz	230 VAC, 50/60 Hz
Voltage Range	105 to 130	195.5 to 253
Power at rated voltage
	5 W	5 W

4.2Mounting

These motion detectors are supplied as desk top half- rack units. For rack mounting, the LTC 9101/00 rack- mount kit is available.

4.3Video Looping Input

There are two smart BNC connectors on the rear panel named IN and LOOP. The camera input should be connected to IN while LOOP may be used as a looping output. The camera input is automatically terminated (nonlooping operation) or unterminated (looping operation).

4.4Monitor Output

The monitor output, named OUT, is designed for a 75 Ω load. Therefore if the monitor output cable is looped through other accessories, ensure that the last unit on the line has its termination set to 75 Ω

Bosch Security Systems December 17, 2004