LTC 2210 Series Instruction Manual Operation | EN 8 |
|
|
5.3Zone Setup
This menu is used to define the areas where motion can be detected. A total of 8 different zones can be defined. Unrestricted areas where motion is permitted and other unnecessary areas should not be included in the active zones. This will eliminate alarms caused by motion in areas which are not considered important for security purposes.
ZONE SETUP
>PREVIOUS MENU DEFINE ZONES
SENSITIVITY3
MOVEMENT2
Select: | ENTER |
Prev Menu:ESC Scroll: | ↓ |
5.4Defining a Zone for Motion Detection
Select the DEFINE ZONES menu.
DEFINE ZONES
>PREVIOUS MENU ADD ZONES EDIT ZONES MOVE ZONES DELETE ZONE DELETE ALL ZONES
Select:ENTER
Prev Menu:ESC Scroll: | ↓ |
Menu options are available to ADD (create a new zone) move, edit
Zones are displayed as a solid rectangular translucent box. Multiple zones can be defined and placed adjacent to or overlapping each other to create more complex shapes.
A single line of help is displayed by default at the bottom of the screen. Zones can also be created over this area. If this hinders defining the zone area, the help information can be removed from the screen by pressing the arrow â, ß keys simultaneously. Pressing these keys again will display the help information once more.
5.5Adding a Zone
To add a Zone, select Add ZONE from the Define Zone menu. A cursor will be displayed on the monitor screen as a small translucent block. Position the cursor where you wish the top left hand corner of the zone to start, and press the ENTER key. This defines a minimum size zone. The zone size increases and decreases as the arrow keys are moved. When the Zone is the desired size and shape; press the ENTER key again to complete the creation of the Zone. The minimum zone area will be approximately 15% horizontal & 15% vertical of the full screen.
5.6Editing, Moving or Deleting a Zone
These options are selected to change the shape, position or remove a zone. Select EDIT, MOVE or DELETE ZONE options from the Define Zone menu. All created zones are displayed on the screen. The arrow á or â keys are used to select the zone to be edited. The presently selected Zone will flash. The ENTER key is pressed to confirm the Zone selection.
For EDIT or MOVE options, the arrow keys can be used to resize or reposition the zone.
For DELETE Zone; a confirmation message is displayed on the screen.
Delete Zone: | NO |
| ↑ |
Scroll:↓↑
Select:ENTER
Previous Menu: ESC
This option must be changed to YES to delete the zone. The Delete All Zones options allows all zones to be removed by one command.
Bosch Security Systems December 17, 2004