LTC 2210 Series Instruction Manual Operatio | EN 7 |
|
|
4.5Alarm/Accessory Connector
A cable with a connector is supplied connecting to alarm closures or other accessories.
The alarm output creates a short between the two output pins (pins 9 and 14 Alarm Relay (NO)) when an alarm occurs and
The Alarm 1 (pin 6) is an
The Remote Alarm Enable Input (pin 15) allows some other security device, such as an access control system, to enable the motion detector. The motion detector is enabled when the Remote Alarm Enable Input is switched to ground (<1 volt) and the Alarm Enable option on the Main Menu is set to REMOTE. The Remote Alarm Enable Input is disabled when the input is not connected or the applied input voltage is greater that 1 volt. The maximum input voltage that can be applied is 15 volts.
Belden 8760 twisted shielded cable (or equivalent) should be used for wiring to the alarm connector and the total length of unshielded cable should not exceed 10 cm (3.9 in.) on each connector port to maintain compliance with Directive 89/336/EEC.
4.6Programming System Setup
Configuration options are provided through
MAIN MENU VER 1.01
EXIT MENUS |
|
ALARM ENABLE | ON |
ZONE SETUP |
|
SYSTEM SETUP |
|
DISPLAY |
|
LANGUAGE | ENGLISH |
Select: | ENTER |
Exit Menu:ESC Scroll: | ↓ |
The first line of each menu gives the menu name. The main menu is the first menu displayed. In addition to the menu name the first line of this menu also displays the version number of the software in this product. All programmable items are given in the lines immediately below the menu name. The last two lines provide help information.
5.0OPERATION
5.1Key Operations
MENU SCROLL: The ↑ or ↓ arrow keys are used to scroll through menu items. The > character indicates the currently selected menu item. The ↑ or ↓ arrow keys are also used to program zone size and placement.
ENTER: Pressing the ENTER key scrolls through the options at current selected menu item.
CHANGE CURSOR POSITION: The ← or → arrow keys are used to position zones and to program alarm capture times.
EXITING A MENU: The ESC key or Previous Menu option is used to exit to a previous menu. If the top level menu is being displayed, pressing the ESC key or selecting the Exit Menu option will exit from Programming.
The Main Menu contains 5 settings. All of these settings access
5.2Alarm Enable
This option is used to switch on the motion detector. When Alarm Enable is ON, the product will detect motion in the active zones defined for motion detection (see Zone Setup). If motion is detected, all alarm outputs will be switched on. When Alarm Enable is set to REMOTE, the unit will detect motion when the external remote alarm input is active (pin 15 of the Alarm Accessory Connector). The input is active when it is switched to Ground.
Bosch Security Systems December 17, 2004