4.Connect white fixture wire to white supply wire (neutral). Secure with wire nut (not provided).
5.Be careful to connect the wires correctly. Make sure no bare strands of wire extend from the wire nut or other approved wire connectors (not supplied).
Attaching access cover and lens
1. Attach the access cover to the light fixture using screws provid-
ed. Access cover should be positioned as shown in P. NOTE: Make sure all wiring is inside of the fixture arm before the access cover is secured.
2.To attach the optical assembly to the housing, first insert the three lens assembly mounting screws into the three holes
P
ENGLISH
inside the fixture. Do not fully tighten the screws at this point. | Q | |
Position the optical assembly over the fixture with slotted holes | ||
| ||
over the mounting screws (Q). Carefully seat the optical assem- |
| |
bly over the mounting screws and rotate the optical assembly |
| |
clockwise until it stops. Tighten all screws. |
|
Installing the light shield
Before installing the lamp, position the light shield over the lamp socket and press firmly into position (R). The shield is friction fitted around the socket. The end of the light shield should be seated in
R
the lip of the lens. You can rotate the light shield in any direction to block the light from the fixture. NOTE: Do not attempt to adjust or touch the light shield while the lamp is on as the light shield gets very hot. If the lamp has been on, allow the light shield time to cool before touching.
Installing the lamp
1.Screw the bulb securely into socket.
2.Back the bulb out one or two turns, then screw bulb back to insure proper position in socket.
Installing the wire grill guard
1.First, locate the two wire tabs on the wire grill. Insert these two tabs in the bottom of the lens.
2. Press the other end of the grill guard in position, and the wire clip | S |
will lock the grill guard in place (S). |
|
3.To remove the grill guard squeeze the wire clip and gently pull the guard out.
Installing the light sensor
1.Make sure the screw in the center of the receptacle (on top of the fixture) is tight.
2.Match up the largest prong on the sensor to the largest slot in the receptacle.
3.Push the sensor down into the receptacle and twist clockwise 1/4 of a turn to lock in place.
4.Turn on the main power at the main fuse/breaker box. NOTE: When the power is initially turned on, the light may come on, even during daylight. However, the light will turn off after two or three minutes and will only come on
4
