Cooper Lighting M2N-E SLI Securing and Wiring the Fixture Head to Pendant

Warning: Before starting any work ensure that all sources of power are turned off. All work must meet local/national codes and be performed by a certified electrician. Do not mount fixtures vertically.

Installation Instructions

Sheet 1 of 3

Roundel, XL

IN/OUTDOOR

P1R (Pendant, 1-way, Remote)

Visor and Non-Visor

3.

Securing and Wiring the Fixture Head to Pendant

Electrical cover plate

Wire connector

Aiming screw spacer

(x2)

1/4-20 x 1" Aiming screw (x2)

	3/8-16 x 1"
	Hex end bolt
End cap	(x2)

1.While firmly supporting fixture head, use 3/8-16 x1" hex end bolt to secure fixture head to yoke arms.

2.Slide one aiming screw spacer between fixture head and yoke arm on each side and secure fixture heads angle using 1/4-20 x1" aiming screws.

3.Remove electrical cover plate from pendant tube.

4.Insert fixture head wire into wire connection at base of pendant tube and run up to electrical cover plate.

5.Attach appropriate wires ensuring all connections are properly matched and replace electrical cover plate.

4.

Electrical cover plate gasket

Wire connectors (x2)

1/4-20 x1" Aiming screw (x2)

End cap (x2)

Aiming and Sealing Fixture

Captive door screws (x10)

40

Side View

1.To aim fixture, unscrew end caps from fixture. Loosen both 1/4-20 x1" aiming screws on both sides of fixture. When yoke indicator and fixture head indicator are lines up the slope of the fixture head is 40-degrees. Each subsequent notch is an additional 10-degrees. When fixture is rotated to desired angle, secure with aiming screws.

2.Secure door using proper torque specifications and sequence as described in supplementary sheet.

3.Thoroughly check seal on all gaskets and wire connectors to ensure seals are smooth and compressed.

ADY080866 REV A(ECN080377)