PORTFOLIO®
Installation Instructions for MAP7 Commercial Recessed Housing with Compact Electronic Ballast
Junction Box Cover |
Housing |
Ballast |
Junction Box |
Mounting Channels |
(Portfolio HB26, HB50 |
Accessories or |
Furnished by Others.) |
Plaster Ring |
CAUTION: To avoid possible electrical shock, be sure that power supply is turned off before installing or servicing this fixture.
Note: This fixture should be supported by main runners or other structure that is capable of supporting fixture weight of 35 lbs.
Step 1 Suggested tools are a
Step 2 To Install Fixture: Using standard bar hangers,
Step 3 Push lampholder into a regressed position (Fig. 1).
FIG 1
Push lampholder into a regressed position
FIG 2 |
| Elongated |
|
| Slot in |
|
| Can |
| White |
|
Ceiling | Trim | Black |
Ring | Baffle |
|
| Step 4 | To Install Trim: With screw driver or needle nose pliers, stretch baffle | WIRING DIAGRAM |
|
|
|
|
|
|
| mounting spring, then hook into elongated slot in the housing |
|
|
|
|
|
|
|
| (Fig. 2). | BLACK INPUT |
| BLACK |
|
|
|
|
|
|
| WHITE |
|
| |
|
|
|
|
|
|
|
| |
|
|
|
|
|
| BLUE/RED | INSULATION |
|
|
| Step 5 | Pull lampholder down and adjust to desired position. |
|
|
|
| |
|
|
|
|
| DETECTOR |
| ||
|
|
|
|
|
|
| ||
|
|
|
|
|
|
| BLUE - 120V |
|
|
| CAUTION: Use with ceramic metal halide lamps approved for use in open | WHITE (COMMON) |
|
| RED - 277V |
| |
|
|
|
|
|
| |||
|
|
|
|
|
|
| ||
|
| fixtures. Do not use an incandescent lamp as this may cause |
|
| WHITE |
|
| |
|
| extremely short lamp life and may damage the ballast. |
|
| BLACK |
|
| |
|
|
|
| ELECTRONIC | BLUE / RED |
|
| |
|
|
|
| BALLAST |
| BLUE |
|
|
|
| NOTE: The electronic ballast has a very improtant "shutdown" timing |
|
|
|
| ||
|
|
|
| GREEN | BLACK |
| ||
|
|
|
|
|
| |||
|
| feature that turns off the ballast output after time periods ranging from 2 |
|
|
| LAMP |
| |
|
| minutes up to 30 minutes if a lamp does not start or operate properly or if |
|
|
|
|
| |
|
| the fixture wiring is improper. For proper system diagnosis and at lamp |
|
|
| WHITE |
| |
|
| replacement time; the INPUT POWER TO THE BALLAST MUST BE RESET |
|
|
|
|
| |
|
| (turn power off, count to 10, and then turn bqack on) to start a new lamp. |
|
|
|
|
| |
Customer First Center • 1121 Highway 74 South • Peachtree City, GA | 30269 • 770.486.4800 • FAX 770.486.4801 | 702847 | Customer First Center • 1121 Highway 74 South • Peachtree City, GA | 30269 • 770.486.4800 • FAX 770.486.4801 | 702847 | |||
|
|
|