Cooper Lighting instruction manual What to do if…, N175MV325-1511.qxd 11/1/05 224 PM Page

N175MV_325-1511.qxd 11/1/05 2:24 PM Page 5

What to do if…

LIGHT DOES NOT COME ON

OR

LIGHT COMES ON FOR ONLY A FEW SECONDS

Is there power to the fixture?

•Has the circuit breaker tripped?

•Is the wall switch ON?

Is the bulb screwed in completely?

•Is the bulb good?

(Be careful not to overtighten.)

Is the sensor functioning properly?

•Is the sensor locked in place?

•Is light being reflected into the sensor, causing the

fixture to turn off?

Is the wiring to the unit loose?

TURN OFF POWER BEFORE CHECKING

• Is the unit properly grounded?

LIGHT STAYS ON

OR

LIGHT CYCLES ON AND OFF

Is the light sensor receiving enough light?

•Change the direction of the light sensor by loosening the screw in the center of the sensor receptacle. NOTE: Do not loosen screw more than 1-1/2 turns. After loosening screw, carefully turn receptacle in desired direction. Tighten screw and reinstall sensor. Do not rotate more than 360 degrees.

Call for customer service and/or missing or damaged parts (800-334-6871)

5