b.Connect black fixture wire to black supply wire (hot). Secure with wire nut (not provided).
c.Connect white fixture wire to white supply wire (neutral). Secure with wire nut (not provided).
d. Be careful to connect the wires correctly. Make sure no bare strands of wire extend from the wire nut or other approve wire connectors (not provided). After the connections are made, the connections should be placed into the extension arm.
Step 3: Install the connection cap into the open end of the extension arm and secure with (2) small screws (K). The screws will go through the notches at the bottom of the extension arm.
Step 4: Install conduit to the conduit connector located in the connection cap just installed on the extension arm in Step 3.
Step 5: Connect the other end of the conduit to a second conduit connector and attach to the junction box. Make wiring connections inside of the junction box.
Installing the bulb
Step 1: Screw the bulb securely into socket.
Step 2: Back the bulb out one or two turns, then screw bulb back to insure proper position in socket.
Installing the light sensor
Step 1: Make sure the screw in the center of receptacle (on top of fixture) is tight.
Step 2: Match up the largest prong on the light sensor (D) to the largest slot in the receptacle.
Step 3: Push sensor down into receptacle and twist clockwise 1/4 of a turn to lock in place.
Step 4: Turn on the main power at the main fuse/breaker box.
Note: When power is initially turned on, the light may come on, even during daylight. However, the light will turn off after two or three minutes and will only come on at dusk thereafter. If artificial light sources (such as car headlights) come in contact with the photo control, it may activate the photo control and turn off the fixture. If this occurs, the fixture will have to cool down for approximately 5 minutes before it will come on again.
Call for customer service and/or missing or damaged parts
4
