Cooper Lighting N175MV instruction manual Putting up your fixture, Wiring your fixture

N175MV_325-1511.qxd 11/1/05 2:24 PM Page 3

•Always use same wattage and type of bulb that was included with the fixture. Failure to do so will void the warranty.

Putting up your fixture

Note: This fixture is intended to be conduit connected to a properly installed and properly grounded metal weatherproof junction box (not provided). All conduit connectors, conduit, and junction boxes (not provided) should be cULus Listed suitable for wet location use.

Step 1: Attach the two piece mounting brackets (I) to the extension arm (N) by interlocking the bracket and securing with the 1/4-20 carriage bolt (L) and 1/4-20 hex nut (M) provided. The mounting bracket should be secure leaving approximately one inch of the extension arm protruding out of the bottom of the bracket.

Note: The mounting bracket attaches to the end of the extension arm that has notches cut into it.

Step 2: Place the extension arm assembly onto the desired mounting surface and mark the four hole locations required for mounting. Remove the arm assembly and drill the four marked locations for ease of mounting.

Step 3: Mount the extension arm assembly using the hex head lag screws (H)

provided. Tighten these screws securely before proceeding.

Step 4: Place the arm of the fixture onto the end of the extension arm (O) and route the three wires through the extension arm. Two hex head bolts on the underside of the fixture housing should be backed out enough to slide the extension arm into the housing. Slide access cover (G) between extension arm and arm bracket. Be certain the extension arm is fully seated into the arm of the fixture. Tighten both arm screws to hold the fixture in place.

Note: All three wires should be extending from the	O
bottom of the extension arm at this point.

Step 5: Fasten one piece lens assembly (B) to fixture housing (A) using (2) lens assembly screws (E) and (2) washers (F).

Wiring your fixture

WARNING - RISK OF ELECTRIC SHOCK. Disconnect power at fuse or circuit breaker before installing or servicing.

Step 1: Install the first conduit connector (not provided) into the conduit connection cap (M).

Step 2: Feed supply wires from conduit through the connector and make wire connections with wires extending from extension arm.

a. Attach the ground supply wire to the ground wire coming from the fixture. Secure with wire nut (not provided).

Call for customer service and/or missing or damaged parts (800-334-6871)

3