|
| |
(1) | Remove the 2 screws from the control box cover, then open | Drain pipe side |
| ||
| the cover. Be careful that the cover does not fall. |
|
(2) | Connect the 5P FLAP wiring connector from the ceiling | Control box |
| panel to the connector on the control PCB in the control box. |
|
| (Fig. | Refrigerant tube side |
|
| |
(3) | Connect the 7P IND and 4P RC wiring connector from the | Indicator cover |
| indicator to the connectors on the control PCB in the control | |
| Power box | |
|
| |
| box. (Fig. | As to how to attach the indicator cover, refer to |
(4) Be sure to use the clamps to fasten the connector wires in
place. (Fig. |
| Fig. |
|
|
| |
|
|
|
|
| ||
(5) Tighten the 2 cover screws to | Ceiling panel | Indoor unit |
|
|
| |
5P FLAP wiring connector | Indicator | 7P IND and 4P RC | ||||
close the cover. | ||||||
|
| wiring connector | ||||
Check that the wiring | Clamps |
|
|
|
| |
connectors are not caught |
|
|
|
| 4P | |
between the electrical |
|
| 5P |
| ||
|
| FLAP | INDRC | |||
component box and the cover. |
|
|
| |||
|
|
|
|
| ||
If the indicator connector is |
| 5P FLAP |
|
| 7P | |
not securely connected, |
| wiring connector |
|
| ||
the remote controller |
|
|
|
|
| |
signal will not be |
|
|
|
|
| |
received. |
|
|
|
|
|
If the connectors are not connected, the auto flap will not operate. Be sure
to connect them securely. | Indicator | 7P IND and 4P RC wiring connector | Control box |
| |||
|
|
|
* Pass the wiring connectors through the clamps to fasten them in place, as shown in the figure.
Fig.
A. Attaching the corner cover
(1) Check that the safety strap from the corner cover is fas- tened to the ceiling panel pin, as shown in the figure. (Fig.
(2) Use the supplied screws to attach the corner cover to the ceiling panel.
B. Attaching the air-intake grille
To install the
from any of 4 directions. (Fig.
Pin
Place the corner cover so that the 3 tabs fit into the holes in the ceiling panel.
Then fasten it in place with the supplied screws.
Fig.
* The grille can be installed
When attaching the
not become caught.
Be sure to attach the safety cord that prevents the
in Fig. 6-24.
Hook that prevents the grille from dropping
Fig.
with these hinges facing in any of 4 directions.
Can be installed rotated 90
Fig.
16