USING THE 1-HOUR OFF TIMER
1. 1-Hour OFF Timer
This function causes the unit to operate for one hour and then stop, regardless of whether the unit is on or off when this button is pressed.
The indicator in the display indicates that this function is operating.
Setting procedure:
Regardless of whether the unit is operating or stopped, press the 1 HR. TIMER button.
appears in the display.
Cancellation procedure:
Press the ON/OFF operation button to turn the unit off, wait for the unit to stop operating, and then press the ON/OFF operation button again.
The
NOTE
•If, while the
•It is not possible to use the OFF Timer and
2.Operation together with the daily ON/OFF repeat timer
The
TIPS FOR ENERGY SAVING
Avoid
•Do not block neither the air intake nor the air outlet. It may cause less performance, and may leads to malfunctions.
•Do not let direct sunlight into the room. Use sunshades, blinds or curtains. If the walls and ceiling of the room are warmed by the sun, it will take longer to cool the room.
Do
•Always try to keep the air filter clean. (Refer to “CARE AND CLEANING”.) A clogged filter will impair the performance of the unit.
•To prevent conditioned air from escaping, keep windows, doors and any other openings closed.
ADJUSTING THE AIRFLOW DIRECTION
The vertical airflow can be adjusted by moving the flap with the remote controller. Do not move the flap with your hands. Confirm that the remote controller has been turned on. Use the FLAP button to set either the sweep function or one of the six airflow direction settings.
A. Sweep function
The flap starts moving up and down to deliver air over the sweep range.
B. Setting the airflow manually | SWEEP |
Referring to the above | |
illustration, use the | COOL |
FLAP button to set the | DRY |
airflow direction within | FAN |
the range used during |
|
the cooling or |
|
dehumidifying operation. |
C. Auto flap function
The flap is set to the recommended position.
NOTE
The flap automatically closes when the unit is off.
CAUTION
•Use the FLAP button on the remote controller to adjust the position of the flap. If you move the flap by hand, the flap position according to the remote controller and the actual flap position may no longer match. If this should happen, shut off the unit, wait for the flap to close, and then turn on the unit again; the flap position will now be normal again.
•Do not have the flap pointed down during cooling operation. Condensation may begin to form around the air vent and drip down.
12