Operation With The Remote Controller

1. Operation

STEP 2

STEP 3

STEP 4 STEP 1 STEP 5

NOTE	Check that the circuit breaker on the power panel is
	turned on.
	turned on.
	Press the setting buttons as described below and
	change the settings as desired.

	STEP 1	Press the MODE selector button
		and select the desired mode.
		For dehumidifying operation			ο
		For cooling operation			ο
		For fan only operation			ο

	STEP 2	To start the air conditioner, press the ON/
		OFF operation button.

	STEP 3	Press the TEMP. setting buttons to change
		the temperature setting to the desired
		temperature.
		Adjustable temperature range:
		30 °C max.	or	86 °F max.
		16 °C min.		60 °F min.

	STEP 4	Set the FAN SPEED selector button to the
		setting you want.

	STEP 5	Press the FLAP button and set the airflow
		direction as desired.
		(Refer to “ADJUSTING THE AIRFLOW
		DIRECTION” on page 12.)

	To stop the air conditioner, press the ON/OFF
	operation button again.
	• Choose the best position in the room for the remote
NOTE	• Choose the best position in the room for the remote
	controller, which also acts as the sensor for room
	controller, which also acts as the sensor for room
	comfort and transmits the operating instructions.
	Once you’ve found this best position, always keep the
	remote controller there.

•This appliance has a built-in 5-minute time delay circuit to ensure reliable operation. When the operation button is pressed, the compressor will start running within three minutes. In the event of power failure, the unit will stop.