Panasonic CU-KS12NK1A Automatic Operation, only for COOL/DRY/HEAT Model, Manual Operation, Step

OPERATION WITH THE REMOTE CONTROLLER

1.Automatic Operation

(only for COOL/DRY/HEAT Model)

•Single use

This unit automatically switches between cooling operation and heating operation according to the difference between the room temperature and the temperature setting.

•Multiple use

The air conditioner calculates the difference between the thermostat setting and room temperature, and automatically determines the mode to operate under cooling or heating. Then, the air conditioner continuously operates under the mode selected at initial operation.

STEP 2

STEP 1

NOTE Check that the circuit breaker on the power panel is turned on.

Once mode is selected and the unit is preset by following the steps below, you can have the air conditioner automatically bring the room to the desired temperature simply by pressing the ON/OFF operation button.

STEP 1 Press the MODE selector button to .

STEP 2 Press the ON/OFF operation button.

To stop the air conditioner, press the ON/OFF operation button again.

NOTE To change the temperature setting; press the temperature setting buttons and change the setting to the desired temperature.

2. Manual Operation

	STEP 2
	STEP 3
STEP 4	STEP 1
STEP 5

NOTE	Check that the circuit breaker on the power panel is
	turned on.
	If the automatic operation settings of the unit do not
	meet your needs, press the setting buttons as
	described below and change the settings as desired.
	STEP 1	Press the MODE selector button
		and select the desired mode.
		For heating operation	ο
		For dehumidifying operation	ο
		For cooling operation	ο
		For fan only operation	ο
		(No Fan mode in “Multiple use” of
		COOL/DRY/HEAT Model)
	STEP 2	To start the air conditioner, press the ON/
		OFF operation button.
	STEP 3	Press the TEMP. setting buttons to change
		the temperature setting to the desired
		temperature.
		Adjustable temperature range:
		86 °F max.
		60 °F min.
	STEP 4	Set the FAN SPEED selector button to the
		setting you want.
	STEP 5	Press the FLAP button and set the airflow
		direction as desired.
		(Refer to “ADJUSTING THE AIRFLOW
		DIRECTION” on page 10.)
	To stop the air conditioner, press the ON/OFF
	operation button again.
	• Choose the best position in the room for the remote
NOTE
	controller, which also acts as the sensor for room
	comfort and transmits the operating instructions.
	Once you’ve found this best position, always keep the
	remote controller there.

•This appliance has a built-in 5-minute time delay circuit to ensure reliable operation. When the operation button is pressed, the compressor will start running within three minutes. In the event of power failure, the unit will stop.

•The display on the remote controller shows the setting temperature and not the room temperature.

•When multiple indoor units are used and units in other rooms are already operating, they will be operating with the same mode as the operating indoor units. (only for “Multiple use” of COOL/DRY/HEAT Model)

7