Hardwire Conduit Option (201 & 301 Models, cont.)
Hardwire Conduit Option (451 Models, cont.)
7 | Green | 8 |
(Ground) | ||
|
| 2 |
12
5 | 6 | ||
|
|
|
|
White
(Neutral)
1 1
3 |
| 3 |
|
| |
| 4 | x4 |
| 1 | |
|
|
1 | 2 |
|
Black (Line)
2
Connect ground wire. Tighten screws on strain relief. | Run wire through grommet on bottom pan. |
Note: Reinstall front plate. | Replace bottom pan. |
Hardwire Conduit Option (451 Models) |
Attach UL approved 3/4” strain relief (not included) to | Connect wires to terminal block. |
bottom of terminal box. Run wires through strain relief. |
|
1 | 2 |
|
| 3 |
|
| 2 |
| 1 | x4 |
|
| |
Remove any loose items in the dishwasher and carefully | Remove bottom pan. Note: Rapid removal of the bottom pan will | |
lay the dishwasher on its back. Note: Be careful not to | cause damage to the moisture sensor. For installation and servicing, | |
pinch hoses or power cord beneath dishwasher. | slowly pull the bottom pan from the unit and disconnect the wire from | |
| the moisture sensor, which islocated in the center of the pan. |
7
2
Green | 1 | |
(Ground) | ||
|
3
Connect ground wire. Tighten screws on strain relief. Note: Reinstall terminal block cover and front plate.
8
2
4 1
Run wire through grommet on bottom pan.
Replace bottom pan.
3
x4
3
3
1
x2
2
Remove front plate.
4
3
1
2
Remove terminal block cover. Remove factory installed
power cable from terminal block.
14 | 15 |