Viking 301 Installation cont, Leveling, in the base. Note Be careful not to pinch hoses or

Installation
1
2
2
1	4
	x4	1
	3	2
Carefully lay dishwasher on its back and attach the kick		To adjust the depth of the kick plate, loosen screws on
plate brackets. Screws for the brackets will already be		the bracket and position in the required depth. Tighten
in the base. Note: Be careful not to pinch hoses or		screws and repeat for other side.
power cord beneath dishwasher.

3 4a

1

1

	2
	x2
Using tie strap attached to dishwasher, band water line,	For installation with trim, attach brackets with two
drain line, and power cord together.	screws (1 per bracket).

4b	5
	1
	1
	2
	x2

Installation (cont.)

6 1

2

Slide unit into opening; be sure to feed water, electrical

and discharge lines into adjacent cabinet.

Leveling

7a Equal distance

DOWN

UP
DOWN	UP

For 301 & 451 models, place a level on handle, then adjust to appropriate height. Left and right adjust side to side and center adjusts front to back.

8

7b Equal distance

1	O	N
	W		2
			UP

For 201 models, remove front panel to access the front

leveling legs. Leveling legs will be raised during

shipping. Adjust front leveling legs down using a 1/4 drive ratchet. When the adjustment nut is visible, complete the lowering of the legs from the top. When the legs are down, tighten the locking nut on the top of the leg. To level center rear leg, see Step 7a.

For installation without trim, attach brackets with two	Position unit in front of cutout.
screws (1 per bracket).

To check level, front to back, pull the top rack half-way out of unit. The rack should remain stationary and not move in or out.

Note: Leveling is important for optimal performance.

18 19