Final Installation
9a
9b
Final Installation (cont.)
12c | Air Gap | 12d | Air Gap |
|
|
1
x4 | x2 | x2 |
2 |
|
|
| 3 |
|
For installation with trim, secure dishwasher by | For installation without trim, secure dishwasher by | (Discharge with air gap) | (Discharge with food waste disposer and air gap) |
attaching provided mounting plugs and wood screws | attaching screws through top brackets into cabinets. |
|
|
through trim panels into cabinets. Attach screws |
|
|
|
through top brackets into cabinets. |
|
|
|
10 | 11 | 13 | 14 |
1.0” |
(2.5 cm) |
Minimum |
|
|
|
20” |
|
|
|
(50.8 cm) | Cut here for |
|
|
from floor |
|
| |
5/8” (1.6 cm) |
|
| |
|
|
| |
| Cut here for |
|
|
| 3/4” (1.9 cm) |
|
|
Install High Loop Clip, which is provided, a minimum of | Identify discharge connection size; cut line to correct | Connect water line. | Plug LED light into dishwasher (select models only) |
20” (50.8 cm) from the floor. Refer to the Drain section | size and connect. Clamp if necessary. |
| and install kick plate. |
of "General Information" for proper installation |
|
| Note: DO NOTblock the dry air exhausts (rectangular |
requirements. |
|
| slots on the access panel) with kick plate or base board. |
|
|
| Blocking the opening could reduce the dry performance |
12a | 12b |
| and cause unwanted condensation. |
|
|
(Discharge with food waste disposer) | (Standard discharge) |
Note: Be sure to remove the knockout or plug from the |
|
fitting of the disposer before connecting drain line. |
|
20 | 21 |