TM
INSTALLATION INSTRUCTIONS
IMPORTANT: Read carefully before installing fixture. Retain for future reference.
Epic/Wall Mounted
Fixtures
Sheet 1 of 4
10/18/05 IMI-658
General: Upon receipt of fixture thoroughly inspect for any freight damage, which should be brought to the attention of the delivery carrier. Compare the catalog description listed on the packing slip with the fixture label on the housing to assure you have received the correct merchandise.
Safety: This fixture must be wired in accordance with the national electrical code and applicable local codes and ordinance. Proper grounding is required to insure personal safety. Carefully observe grounding procedure under installation section. All work should be done by a qualified electrician.
WARNING: Risk of Electric Shock. Disconnect power at fuse or circuit breaker before installing or servicing.
ARM INSTALLATION
Bishop Arm
&
1.Secure arm mount flush with wall using 3/8” hardware supplied
by others.
2. Remove wireway cover screws and wireway cover.
3. Mount arm to arm mount positioning service leads in wireway. Insert and tighten four screws to 80 in/lbs.
4.Pull fixture leads through arm.
5.Align locating pin and socket when raising fixture to arm. See Figure 2.
6.Insert and tighten 4 fixture screws with Teflon washers, provided in polybag, to 80 in/lbs.
7.Connect fixture leads to service leads in wireway.
8.Resecure wireway cover with wireway cover screws tightened to 50 in/lbs.
Backplate Med
Bishop Wall
(4)
(4)3/8" Lag Bolts (supplied by others)
Wireway Cover | Wireway Cover |
| Srews (2) |
Bishop Arm
Fixture Screws (4)
Teflon Washer (4)
Fig. 1
Traditional Arm
SA6104 &
See Figure 3.
1.Secure arm mount flush with wall using 3/8” hardware supplied by others.
2.Remove wireway cover screw and wireway cover.
3.Mount arm to arm mount positioning service leads in wireway. Insert and tighten set screw to 80 in/lbs.
4.Pull fixture leads through arm.
5.Align locating pin and socket when raising fixture to arm. See Figure 2.
6.Insert and tighten 4 fixture screws with Teflon washers, provided in polybag, to 80 in/lbs.
7.Connect fixture leads to service leads in wireway.
8.Resecure wireway cover with wireway cover screw tightened to 50 in/lbs.
Modern Top
Aligning Pin 
Aligning Socket
Fig. 2a
These instructions do not claim to cover all details or variations in the equipment, procedure, or process described, nor to provide directions for meeting every possible contingency during installation, operation or maintenance. When additional information is desired to satisfy a problem not covered sufficiently for user’s purpose, please contact your nearest representative.
Customer First Center • 1121 Hwy 74 South • Peachtree City, GA 30269
