TM
INSTALLATION INSTRUCTIONS
IMPORTANT: Read carefully before installing fixture. Retain for future reference.
Epic/Wall Mounted
Fixtures
Sheet 2 of 4
10/18/05
A. Relamping
Horizontally lamped1. Loosen two door screws.
2. Lower door to tethered resting position. See Figure 4.
3.Install suitable lamp. Consult
4.Raise door and secure with screws.
Vertically lamped1.Loosen and remove ring retaining screws globe retaining ring and globe. Components are not tethered.
See Figure 5. (closeup of lowered globe and ring)
2.Install suitable lamp. Consult
3.Reinstall ring retaining screws securing globe retaining ring and globe. In the case of type 3 refractive glass globe, use the mark on globe bottom for orientation.
B. Starter and Fuse Replacement (Where applicable)Horizontally lamped
1.Loosen two door screws.
2.Lower door to tethered resting position. See Figure 4.
3.Loosen thumbscrew until rectangular washer can be rotated 90 degrees. See Figure 6.
4.Rotate reflector faceplate to release from screws using key hole slots.
5.Unplug optic
6.Remove two screws on ballast cover followed by ballast cover. See Figure 7.
7.For starter replacement, remove the
For fuse replacement, unscrew fuse holder cap and replace fuse. Resecure fuse holder cap.
8.Resecure the ballast cover with the two screws.
9.Plug optic
10.Raise door and secure with screws.
Aligning Socket
Aligning Pin
Fig. 2b
Traditional ArmArm Mount
Mounting Hardware |
| Fixture Screws |
(supplied by others) | Wireway Cover Screws | Teflon Washers |
| ||
|
| |
| Wireway Cover |
|
Fig. 3
Fig. 4a | Options |
| Flat Lens or Sag Lens |
Door Screws
Customer First Center • 1121 Hwy 74 South • Peachtree City, GA 30269
