Cooper Lighting SA6001-SA6002 Sheet 4 of, b, Installation Instructions, 10/18/05 IMI-658

TM

INSTALLATION INSTRUCTIONS

IMPORTANT: Read carefully before installing fixture. Retain for future reference.

Epic/Wall Mounted

Fixtures

Sheet 4 of 4

10/18/05 IMI-658

WARNING: Risk of Electric Shock. Disconnect power at fuse or circuit breaker before installing or servicing.

Vertically lamped

1.	Loosen and remove ring retaining screws globe retaining
	ring and globe. Components are not tethered.
	See Figure 5.
2.	Remove two screws on ballast cover followed by ballast
	cover. See Figure 6.
3.	Unplug optic quick-disconnect.
4.	Unplug service quick-disconnect.
5.	Loosen the two screws holding the power pack to the
	fixture housing. See Figure 7.
6.	Holding the power pack by the handle, rotate the power
	pack until free and lower.
7.	Holding replacement power pack by handle, raise onto
	screw heads and rotate.
8.	Tighten the two screws while holding power pack in
	position.
9.	Plug together the service quick-disconnect.
10.	Plug together the optic quick-disconnect.

Ballast Cover

Screws

Optic

Quick-

Disconnect

Fig. 7a

11.	Resecure the ballast cover with the two screws.
12.	Reinstall ring retaining screws securing globe retaining ring
	and globe. In the case of type 3 refractive glass globe, use
	the mark on globe bottom for orientation.

Fuse

Handle

Starter

Reflector

Keyhole Slot

Removal

Rectangular Washer

Thumbscrew

Fig. 6

Service

Quick-Disconnect

Fig. 7b

Screws

Power Pack Removal Fig. 8

These instructions do not claim to cover all details or variations in the equipment, procedure, or process described, nor to provide directions for meeting every possible contingency during installation, operation or maintenance. When additional information is desired to satisfy a problem not covered sufficiently for user’s purpose, please contact your nearest representative.

Customer First Center • 1121 Hwy 74 South • Peachtree City, GA 30269 IMI-658 ADW051684