Cooper Lighting TQS1000 Use as a stand light, Use as a portable light, Fig. 5, Bonus bulb included, Fig. 3, Fig. 4

ENGLISH

Call for customer service and/or missing or damaged parts (800-334-6871)

Step 4: Using a phillips screwdriver, mount the “Y” cord to the back of the

center handle. Athreaded hole is provided.

Step 5: To install the wire safety guard, insert one side of the guard between

the frame and lens. Squeeze the guard until the other side can be

placed between the opposite side of the frame and lens.

Use as a stand light

Step 1: Unlock legs first by pulling each leg out

approximately 1˝, then loosen the knob at the

top of the leg assembly and pulls legs out,

extending to full open position so that the top

black bracket slides down until it is lined up with

the red line on the center pole label (Fig. 3).

Retighten knob.

Step 2: Attach portable fixture to the vertical pole by

placing the Quick-release

™collar over the top

of the tube. Tighten the knob on the collar until

the screw is secure (Fig. 4).

Step 3: Plug light into a GFCI protected 120 volt receptacle.

Step 4: To turn light ON or OFF, push red switch on the

back of each fixture.

Step 5: Adjust the tripod stand to the desired height by loosening and

tightening the locking collars on the pole.

Step 6: On uneven terrain, position the extendable leg toward the lowest point

on the surface. Extend the leg by loosening the locking collar, pulling

the leg out, and tightening the collar.

Note: Legs must be secured with sand bags or other suitable weight:

• When used on uneven or rocky surfaces.

• When used in windy areas.

• Anytime extra stability is required.

Use as a portable light

Step 1: If using as a stand light, remove the portable fixture from vertical

pole by turning the Quick-release™knob counterclockwise until

loose. Lift portable unit from pole.

Step 2: Use the light fixtures by setting the built-in stand on any flat surface.

Step 3: For maximum safety, portable light fixtures should always be

plugged into a GFCI (Ground Fault Circuit Interrupter) protected,

120 volt circuit.

Step 4: To turn light ON or OFF, push red switch on the back of each fixture.

Bonus bulb included

This fixture includes a spare bulb, which insures that you can

always finish your job or project without interruption due to bulb fail-

ure. The spare bulb and holder are located in the center handle of

the portable fixture (Fig. 5).

Slide bracket

down to line

up with red

mark on

label

Fig. 3Fig. 4Fig. 5

TQS1000325-1533.qxd 4/3/06 1:45 PM Page 4