24/90V MESSAGE WAITING LAMP
If your phone is installed behind a Message Waiting enabled PBX, you will need to set the MW switch in order to receive the Message Waiting indication.
1.Locate the switch on the bottom of the telephone.
2.For 90V PBX Message Waiting Indication, move the switch to the position marked “90V”. For 24V PBX Message Waiting Indication, move the switch to the position marked “24V”. If connecting directly to telephone lines, move the switch to the center “OFF” position.
Warning: Setting this switch in a position other than OFF can cause this phone to function incorrectly. When enabled, this feature is for PBX systems, and not meant for direct Central Office (CO) interface. If connecting to CO telephone lines, make sure this switch is set to OFF.
L1/L2 L 2
DESK MOUNT INSTRUCTIONS
1. Mounting wedge should already be installed onto the base. If not, Install mounting wedge onto telephone base.
2. Connect the adapter and the line cord. See Steps 2 & 3 under “Installation” for specific instructions.
3. Plug the short end of the coiled cord into the handset jack, and then plug the other end of the cord into the base.
4. Place the handset on the base.
Note: To alter the mounting bracket angle, pull the lever up and rotate the mounting wedge. There are 5 available angles.
2
