IMPORTANT SAFETY INSTRUCTIONS
Always follow basic safety precautions when using your telephone equipment to reduce the risk of fire, electrical shock, and injury.
1.Read and understand all instructions in the Owner’s Instruction Manual.
2.Read all warnings and follow all instructions marked on the product.
3.Unplug this product from the wall outlet before cleaning. Use a damp cloth for cleaning. Do not use liquid or aerosol cleaners.
4.Do not use the telephone near water. For example, do not use near a bathtub, wash bowl, kitchen sink, laundry tub, swimming pool, or in a wet basement.
5.Do not place this product on an unstable cart or stand. The product may fall causing serious damage to the product.
6.Do not place any objects on the telephone line cord. Do not locate the telephone where the line cord will be walked on.
7.Do not block or cover ventilation slots and openings in the bottom of the telephone. The openings should never be blocked by placing the telephone on a bed, sofa, rug, or other similar surfaces. This telephone should never be placed near or over a radiator or heat register. This telephone should never be placed in a
8.Never spill liquid on the telephone or push objects of any kind through ventilation slots. Liquid or objects may touch dangerous voltage points or short out parts that could result in a risk of fire or electrical shock.
9.Do not disassemble this product. Opening or removing covers may expose you to dangerous voltages or other risks. Incorrect reassembly can cause electrical shock when the product is subsequently used.
10.Avoid using a telephone during a local thunderstorm. There may be a remote risk of electrical shock from lightning.
11.Do not use a telephone in the vicinity of a gas leak to report the leak, or otherwise.
12.Unplug the telephone from the wall outlet and refer servicing to qualified service personnel under the following conditions:
•When the line cord is frayed or plugs damaged.
•If liquid has been spilled into the telephone.
•If the telephone has been exposed to rain or water.
•If the telephone does not operate properly by following the operating instructions.
•If the telephone has been dropped or the housing damaged.
•If the telephone exhibits distinct change in performance.
SAVE THESEINSTRUCTIONS
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, in- cluding interference that may cause undesired opera- tion.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compli- ance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a CLASS B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harm- ful interference in a residential installation. This equip- ment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encour- aged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio TV techni- cian for help.
THE FCC WANTS YOU TO KNOW
DESIGN COMPLIANCE Your telephone is designed to comply with FCC Rules and Regulations, Part 68. It can be connected to the telephone network as
NOTIFICATION TO THE TELEPHONE COMPANY As a customer of the local telephone company, you must, if they ask, tell them before connecting your telephone to the telephone company lines. The telephone company may need the FCC registration number and the ringer equivalence of the telephone. This information is printed on a label on the bottom of your telephone.
RINGER EQUIVALENCE The ringer equivalence indicates the amount of power that your telephone draws from the telephone company line during ringing. The number is printed on the label on the bottom of your telephone.
If you have more than one telephone (or other terminal device) connected to the telephone company line, you should total the ringer equivalence numbers (REN’s), and be sure that the total is not more than five. Your telephones may not ring if the total is more than five. Also, in some rural locations, your telephone may not ring if the REN total is more than three.
RESTRICTIONS You must not connect your telephone to coin- operated lines or party lines.
INTERFERENCE POTENTIAL Your telephone has a
INSTALLATION This model telephone must be connected to the telephone company lines through a modular jack. The required USOC for the modular jack is RJ11C for desk mounting and RJ11W for wall mounting. The USOC number is printed on the label on the bottom of your telephone.
TYPE OF DIALING Your telephone has a
IN CASE OF TROUBLE If your telephone should cause problems on the telephone line, the telephone company can temporarily disconnect your service. The telephone company must then notify and allow you to correct the problem.
The telephone company may from time to time change its lines or equipment. They must notify you if planned changes will affect your telephone service, to allow you to take steps to prevent interruptions.
