Country Home Products A2080BMA, A2080BEA manual All-Terrain Mower, Belt Installation Figures

ASSEMBLY & INSTALLATION

!WARNING: Before installing the DR® SNOW THROWER, always bring the DR® ALL- TERRAIN™ MOWER to a complete stop, shut off the engine and remove the spark plug wire.

Step 3: Installation (Figure 3)

1.Remove the mowing deck from the DR®

ALL-TERRAIN™MOWER.

2.Apply grease on the shaft (item 6).

3.Remove bolts (item 5) from belt cover.

4.Remove the belt cover (item 4).

5.Align the DR® ALL-TERRAIN™MOWER and DR® SNOW THROWER. Carefully, insert the shaft (item 6) of the ALL- TERRAIN™ MOWER into the female attachment on the SNOW THROWER.

6.Reinstall the collar and pin used with the mower to secure the SNOW THROWER.

Figure 3

Step 4: Belt Installation (Figures 3 & 4)

1.Carefully install the drive belt (item 1) around the drive pulley (item 2) under the DR® ALL-TERRAIN™MOWER.

2.Pull the tensioner (item 3) to reinstall the belt on the idler. Make sure that the V-belt is not twisted and fits correctly in the V-groove on the pulley.

3.Make sure to position the belt above the belt guide, as shown in figure 4.

4.Reinstall the belt cover (item 4) and bolts.

Figure 4

12 DR® SNOW THROWER Safety, Operation & Maintenance Instructions