Country Home Products A2090TMA manual Rotation Handle Installation Figure, Assembly & Installation

ASSEMBLY & INSTALLATION

Step 5: Rotation Handle Installation (Figure 5)

1.On the left side handlebar of the DR® ALL- TERRAIN™ MOWER, install the rotation handle support (item 1) at approximately 28" from the ground, using the U-bolt (item 2), plate and nuts.

2.Insert the plastic bushing (item 3, flange facing the operator) on the housing by pushing forward until it snaps.

3.Insert the worm shaft (item 4) in the plastic bushing.

4.Place the flat washer (item 5) and lock the shaft in place with the cotter pin (item 6).

5.Insert the plastic bushing (item 3, flange facing the operator) into the rotation handle support (item 1).

6.Insert the rotation handle (item 7) through the support then in the worm shaft (item 4). Secure with the hairpin (item 8).

7.Operate the handle and check for proper operation of the chute.

Figure 5

!WARNING: Make sure the chute blocks in both directions to prevent the snow from being projected in the operator's area (Figure 6).

Figure 6

DR® SNOW THROWER Safety, Operation & Maintenance Instructions 13