PRE-OPERATION CHECK LIST
|
|
| |
|
| ||
(OPERATOR’S RESPONSIBILITY) |
|
| |
___ | Review and follow all safety rules and safety | ___ | Never allow riders. |
| decal instructions. | ___ | Inspect area and remove stones, branches or |
___ | Check that all safety decals are installed and in |
| other hard objects that might be thrown, |
| good condition. Replace if damaged. |
| causing injury or damage. |
___ | Check to make sure all shields and guards | ___ | Clean area around oil fill dipstick. Remove |
| are properly installed and in good condition. |
| dipstick and check to be sure oil is in operating |
| Be sure that either the discharge shield or |
| range (between marks on dipstick). Add oil if |
| complete vacuum attachment is installed. |
| necessary but Do Not Overfill. Install dipstick |
___ | Check that all hardware is properly installed. |
| assembly firmly until cap bottoms out on tube. |
| and secured. |
| Dipstick assembly must always be secured into |
___ | Check that equipment is properly and securely |
| fill tube when engine is running. |
| attached to power unit. | ___ | Check all lubrication points and grease as |
___ | Check to be sure engine is free of dirt and |
| instructed in manual. |
| debris. Pay particular attention to the cooling | ___ | Check hydrostatic fluid level. Check to be sure |
| fins, governor parts and muffler. Clean air |
| cooling fins on hydrostat are clean. |
| intake screen. Check air cleaner; service if | ___ | Perform a functional check of the safety |
| necessary. |
| interlock system each time you operate the |
|
|
| unit. |
|
|
|
|
|
|
|
|
18
