BELT REPLACEMENT
NOTE: Always use Craftsman Professional replacement belts, not general purpose belts. Craftsman Professional belts are specially designed for use on this mower and will nor- mally last longer.
Cutterdeck belt
1. Remove floorplate.
2. Set the cutterdeck in a middle
3. Use a 3/8" ratchet and extension to back tensioning idler off to remove belt from idler. Remove belt from cutterdeck pulleys.
NOTE: Use the 3/8" ratchet in the square hole A on the idler.
4.Remove belt from clutch pulley.
5.Install the new belt by performing these steps in
reverse order. | 3 SPINDLE DECK |
HYDRO TRANSAXLE DRIVE belt
1.Remove cutterdeck belt (see cutterdeck belt replacement).
2.Disconnect wire I at clutch M. Remove bolts J and remove torque restraint.
3.Using a ratchet with a 9/16" socket, place over nut at location P. Use the ratchet to rotate it enough to remove the transaxle drive belt.
4.Install a new transaxle drive belt by performing these steps in reverse order.
5.Inspect the fans. Replace if worn or damaged. Torque transaxle pulley nut to
6.Reinstall cutterdeck belt (see cutterdeck belt replacement).
BELT TENSION
All belts are tensioned by spring loaded idlers and do not require any adjustment.
34