Craftsman 137.21602 operating instructions Dust Blower FIG. D, Sawdust Collection Port FIG. E, F

THE DUST BLOWER (FIG. D)

1.Locate the sawdust blower tubing (1).

2.Connect the PVC plastic end of the tube to the bellows seat (2).

3.For best results, the dust blower tube should be adjusted to direct air at both the blade and the workpiece.

Fig. D 1

2

SAWDUST COLLECTION PORT (FIG. E, F)

This scroll saw will accept a hose or vacuum accessory (not provided) to be connected to the sawdust collection port (1) on the front of base. If excessive sawdust buildup occurs inside the base, use a wet/dry vacuum cleaner or manually remove sawdust by first unplugging the saw from the power source, then removing the three screws (2) on the left side of saw holding the plate cover. After cleaning all sawdust buildup, reattach the plate and screws before restarting the saw. This will keep your saw cutting efficiently.

Fig. E

2

1

! WARNING

●To prevent fire hazard, clean and remove sawdust from under the saw frequently.

●To prevent sawdust build up inside the saw housing, attach a vacuum

hose (3) to the sawdust collection port (1) at the front of the scroll saw. DO NOT operate the saw with the hose in place unless the vacuum is turned on.

NOTE: A 43-38 mm (1-11/16 in-1-1/2 in) dust port adapter (4) is provided for your convenience.

Fig. F

4 1

3

18