Craftsman 137.21602 operating instructions Fig. Q, Blade Guard Foot Adjustment FIG. S

7.Tighten the lock nut (6).

8.When the blade is exactly 900

(00) to the table, loosen the bevel indicator screw (9) using a Phillips screwdriver.

9.Adjust the bevel indicator (10) to the “0” mark on the bevel scale and retighten the indicator screw (9).

10.Attach the blade guard foot (1) using the T-wrench, so the foot rests flat against the table and

tighten. (Fig. Q)

NOTE: Avoid setting the edge of the table against the top of the motor, which could cause noise when the saw is running.

Fig. Q

2

1

Fig. R

5

6

8

7

4

9

10

3

BLADE GUARD FOOT ADJUSTMENT (FIG. S)

NOTE: User must keep constant downward pressure on workpiece when cutting. The blade guard foot is not designed to hold down the workpiece, but is rather to help prevent the workpiece from lifting up excessively.

When cutting at angles, the table guard foot (1) should be adjusted so it is parallel to the table and rests flat above the workpiece.

1.To adjust, loosen the screw (2), tilt the foot so it is parallel to table and tighten the screw.

2.Loosen the blade guard foot lock knob (3) to raise or lower the foot until it rests slightly above the

workpiece. Tighten blade guard foot lock knob.

NOTE: To remove the blade guard foot (1), loosen the hex screw (2) by using the supplied T-wrench to turn the screw counterclockwise.

Fig. S 4

1

3

2

23