.
9.
Carefully slidethe combination square to the rear
untilthe ruler touches the markedtooth.
If the rulertouches the marked tooth atthe front and
rear positions, no adjustment isneeded at thistime.
If not, perform adjustment procedure described in
nextsection.
Fig. T
Additional blade adjustments (FIG. U)
1. If the front and rear measurements are not the
same, remove the combination square and loosen
the four adjusting screws (1) on the top ofthe table
about a half turn.
2. Witha folded piece of cardboard coveringthe blade
to protect your hands, move the blade careful{y to
the left or right as much as needed to align
the blade correctly.
3. Tighten the four screws (1) and remeasure, as
described in steps 4 to 9 inthe prior section.
4. If sufficient adjustment cannot be made by the four
adjusting screws (1), then also loosen the two
adjusting screws (2). Loosen these screws only
if necessary.
5. Recheck blade clearance making sure that the
blade does not hit the table insert or other parts
when at the 90° and 45° settings.
6. Tighten all screws.
Fig. U
15