1.The trimmer comes assembled except for the safety guard and auxiliary handle, which must be attached.
2.Remove the trimmer, auxiliary handle and safety guard from the carton and inspect your trimmer.
3.Do not discard box or packing material until all parts are examined.
1
/_ WARNING: if any part of the trimmer is missing or damaged, do not plug
in the trimmer until the damaged part is repaired or replaced. | 1 |
|
Fig. 1
3.Auxiliary Handle Mounting Bracket
KNOWYOUR TRIIVIMER / EDGER (Fig. 2, 2a, 2b and 3) | ] |
NOTE: Before attempting to use this product, familiarize yourself with all | |
operating features and safety rules. | |
Your trimmer/edger has a precision built electric motor and it should only be connected |
|
to a |
|
should always be used with a GFCl (Ground Fault Circuit Interrupter) outlet. |
|
DO NOT operate this trimmer on direct current (DC). The large voltage drop would cause a loss of power and the motor would overheat.
If the trimmer does not operate when plugged into correct
check the power supply. The trimmer comes with a
PIGTAIL POWER CORD (Figs. 2, 2a and 2b)
Fig. 2a | Fig. 2b |
4.Knob and Screw to
Loosen or Tighten
Handle (This knob comes attached to
the auxiliary handle and mounts on
right side)
1.Trimmer
5.Edge\Guide
Trimmer
Head
2. Auxiliary Handle
7.4 Screw Holes
for attaching Safety Guard to trimmer
head are located around collar of
safety guard
6. Safety Guard
7.4Screws for attaching Safety Guard are located on the bottom of the head
10
Your trimmer/edger has a
proper extension cord (see page 6). Remove the plug guard from the pigtail power cord (see Fig. 2). Make a loop in the extension cord. Push loop through hole in the handle
(see Fig. 2a). Fasten loop around cord retention hook. Plug trimmer's power cord into extension cord plug (see Fig. 2b).
This Trimmer/Edger has the following features:
1.12=inch Cutting Path
2.Twist and Edge...Two Tools in One...rear handle and upper shaft (and auxiliary handle) easily rotates 180° for trimming or edging.
3.4.0 Amp, 9000 RPM (no=load speed) motor. Provides power for trimming and edging in light to medium duty applications.
4.Ergonomically Designed Rear Handle for maximum control and gripping comfort with reduced operator fatigue.
5.Four finger Trigger Switch for easy on / off.
6.4=Position Trimmer Head easily adjusts to the desired working angle for optimum operator control in all trimming and edging applications. From trimming around
11