SAFETY RULES FOR BATTERY CHARGING STAND cont.
10. | Do not disassemble | charging stand.Take it to a Sears Parts | and Repair | Center |
| when service or repair is required, incorrect reassembly may result in a risk of | |||
| electric shock or fire. |
|
|
|
11. | Disconnect charging | stand from the power supply when net | in use. This | will |
1.The trimmer comes assembled except for the guard and auxiliary handle, which must be attached.
2.Remove the trimmer, auxiliary handle, safety guard, box containing the battery pack and charger, wall mount bracket for charger and wall mount bracket for trimmer with hardware from the carton and inspect your trimmer.
3.Do not discard box or packing material until all parts are examined.
| reduce the risk of electric shock or damage if metal items should fall into the opening | |||||
| in the charging stand, it also will help prevent damage during a power surge. | |||||
12. | Risk of electric shock. | De not | touch uminsulated | portion of output | connector or | |
| uminsulated | battery terminal. |
|
|
| |
13. | Save these | instructions. | Refer | to them frequently | and use them to | instruct |
| others who may use this tool. If you loan someone this tool, also loan them these | |||||
| instructions to prevent misuse of the product and possible injury. |
|
ADDiTiONAL RULES FOR SAFE OPERATION
,/K WARNING: BE SURE to read and understand all instructions. Failure to i follow all instructions listed below may result in electric shock, fire and / or
serious personal injury.
1.ALWAYS wear safety glasses or eye shields when using this tool, Everyday eyeglasses have only
2.PROTECT your lungs. Wear a face mask, dust mask or respirator if the operation is dusty.
3.PROTECT your hearing. Wear appropriate personal hearing protection during use. Under some conditions noise from this product may contribute to hearing loss.
4.ALL ViSiTORS AND BYSTANDERS MUST wear the same safety equipment that the operator of the tool wears.
install the battery Z_ WARNING: or replaced.
Fig. 1
Knob and Screw to
Loosen or Tighten Handle (This knob comes attached to
the auxiliary handle and mounts on
this [right] side)
Trimmer
pack into the | trimmer until | the damaged part is repaired | i |
if any part of | the trimmer | is missing or damaged, do not |
Screws and Anchors for Mounting Brackets
\
Wall Mount Bracket for Trimmer
PPil
7 77
Auxiliary Handle | Wall Mount | Bracket |
| for Charging | Stand |
5, ALWAYS check the tool for damaged parts. Before further use of the tool, a guard or other part that is damaged should be carefully checked to determine if it will operate properly and perform its intended function. Check for misaNgnment or binding of moving
parts, breakage of parts, and any other condition that may affect the tool's operation.
A guard or other part that is damaged should be properly repaired or replaced at a Sears Service center.
6.SAVE THESE INSTRUCTIONS. Refer to them frequently and use them to instruct others who may use this tool. if someone borrows this tool, make sure they have these instructions also.
10
Battery Pack Battery Charging Stand
Safety Guard
11