4.Snapthe cablehousingclips intothe handleassemblycable mount.The redclip (reversecable)fits into thetop positiononthe handleassembly,whilethe blackclip (forward/clutchcable)feeds intothe lowerpositiononthe handleassembly.See Figure3.
5.Clipthe cablesintothe cableguideslocatedon the handle assemblypanelas seenin Figure4.
MOVING THE TILLER OFF THE SKID
Torollthe tiller offthe shippingplatform,putthe wheelsin freewheel,if theyarenotalreadyfromthe factory,as follows:
1.Placea sturdyblockunderthe transmissionto raiseonewheel about1"off theground.Removetheclick pinfromthe wheelhub andwheelshaft. SeeFigure5.
2.Slidethewheelfully inwardon the wheelshaft. Reinstallthe click pinthroughthe wheelshaftonly (notthroughthe wheelhub).See Figure5. The wheelshouldnowspinfreely(freewheel)on the wheelshaft. Repeatwiththe otherwheel.
3.Usethe handlebarto liftand pullthetiller backwardsto a flat area.
NOTE:Beforestartingthe engine,the wheelsmustbe placedin the WHEELDRIVEposition(pins throughwheelhubsandwheelshaft). Thisprocedureis describedinthe operationsectionunderwheeldrive pins.
ff
Red
Reverse
Figure4
Click Pin
Remove the click pin | Slide the | wheel fully | |
from the wheel hub. | inward on the | wheel shaft. | |
(WHEEL DRIVE position) | Reinstall | the | click pin. |
| (Freewheel | position) | |
|
|
| J |
Figure3 | Figure5 |
|
|
9
