Craftsman 247.77011 Removing Unit from Carton, Disconnecting Spark Plug, Attaching the Handle

ASSEMBLY

	Blower	Upper
	Chute
		Handle
Rope
Guide
		Wing
		Nut
20-oz. Bottle
of Engine Oil
Wing		Bag
Nuts
Lower
Handle
Wing
Nuts
Carriage
Screw

Figure 1

IMPORTANT: This unit is shipped without gasoline or oil in the engine. After assembly, see OPERATION section of this manual for proper fuel and engine oil fill-up.

NOTE: Reference to right and left hand side of the Yard Vacuum is observed from the operating position. See Figure 1.

This Yard Vacuum has been completely assembled at the factory, except for the handle, bag, and blower chute. These parts are shipped loose in the carton.

A pair of safety glasses and a 20-oz. bottle of engine oil are also included in the carton. See Figure 1.

REMOVING UNIT FROM CARTON

•Cut the corners of the carton.

•Remove all loose parts.

•Remove packing material.

•Lift unit from the rear to discard packing material from under unit and roll unit out of carton.

•Check carton thoroughly for any other loose parts.

LOOSE PARTS IN CARTON (See Figure 1)

•Handle Assembly

•Bag

•Blower Chute

•Safety Glasses (Not Shown)

•A 20-oz. Bottle of Engine Oil (may be located in bag)

•Operator’s Manual

DISCONNECTING SPARK PLUG

Before proceeding with assembly of your new Yard Vacuum, disconnect the spark plug wire from the spark plug and ground onto the retaining post on the engine. This will prevent accidental starting of the engine. See Figure 2.

Retaining Post

Spark

Plug Wire

Figure 2

ATTACHING THE HANDLE

•Unfold the upper handle until it aligns with lower handle. Make sure the rope guide is on the right side of upper handle. See Figure 1.

5