Installing the KIRK Wireless Server 600v3 47

Note: To expand a coverage area with KWS600v3, additional radio units must be placed in such a way that overlap between the different KWS600v3 radio coverage is established. It is recommended that the overlap is at least 10 to 15 meters/32.8 to 49.2 feet.

Note: Do not paint the KWS600v3 as paint contains material which can cause decreased radio coverage.

4.3.1 KIRK Wireless Server 600v3 Indoor Wall Mounting

For best RF coverage, the KWS600v3 must be mounted vertically on walls.

Caution: The KWS600v3 must not be installed at any angle other than vertical. If the KWS600v3 is placed upside-down, the coverage area of the KWS600v3 is decreased by 40 - 50% and it might not transmit or receive effectively.

Caution: Do not mount the KWS600v3 on soft surfaced walls such as those covered with canvas or sponge-like materials.

To install the KWS600v3 indoors:

1Mount the KWS600v3 on the wall, using the anchors and screws provided.

Note: When you place the KWS600v3 on the screws, ensure that the screws do not touch the printed circuit board.

Figure 11 Wireless Server 600v3 Wall Mounting

2Connect the wire into the RJ45 plug on the KWS600v3.

KIRK Wireless Server 600v3 Installation and Configuration Guide

Page 47
Image 47
Polycom 14117800 Kirk Wireless Server 600v3 Indoor Wall Mounting, Connect the wire into the RJ45 plug on the KWS600v3