Polycom 14117800 manual IP Settings Shared area, Configuration Tool Secondary Settings dialog box

140Configuring KIRK Wireless Server 600v3

Figure 78 Configuration Tool: Secondary Settings dialog box

—In the Host Name field, type the host name. The host name consist of ip1200- followed by the last three octets of the MAC address of the KWS600v3 (to be found on the label on the rear of the KWS600v3). Eg. ip1200-0f-01-9d

Note: When clicking the Get button, the system provides the host name automatically. The Get button can only be used, if working online and if the IP address is the specific IP address of the KWS600v3 in question and valid on the whole network.

—In the Sync Master field, type the radio ID of the Sync Master. See your site planner.

—In the Alt Sync Master field, type the radio ID of the alternative Sync Master. See your site planner.

Note: The radio ID of the Secondary KIRK Wireless Server is by default identical to the last octet of its IP address. It is recommended not to change the radio ID.

— Click OK to close the dialog box.

2In the IP Settings (Shared) area:

•Deselect the DHCP check box.

First time you power up the KWS600v3 it acts as a DHCP client. To assign a specific IP address to the unit, it is necessary to disable the DHCP mode.

•In the Network Mask field, type the network mask.

•In the Default Gateway field, type the IP address of the gateway.

3In the Radio area:

•In the Master field, type the IP address of the Master KWS600v3.

•In the Alt Master field, type the IP address of the alternative (Standby) Master KWS600v3.

4In the LDAP area:

•In the Primary field, type the IP address of the primary LDAP Server.

•In the Alt field, type the IP address of the alternative LDAP Server.

14117800, Ed.2.6