Polycom 14117800 Assigning a Specific IP Address Secondary, Adm. Page Configuration/ETH0/DHCP

Configuring KIRK Wireless Server 600v3 111

7.6.4.2 Assigning a Specific IP Address (Secondary)

To assign a specific IP address to the KWS600v3, it is necessary to disable the DCHP mode and then assign a specific IP address to the KWS600v3. The new IP address and network address will be provided by the system administrator.

Note: It is advisable that the IP addresses for KWS600v3 secondaries are numbered in succession; eg. 192.168.1.3, 192.168.1.4, 192.168.1.5 etc. This makes it easier to detect a specific Secondary KWS600v3.

1Under the Configuration menu, click ETH0, and then click DHCP.

Figure 51 Adm. Page: Configuration/ETH0/DHCP page

2From the Mode list, select Disabled, and then click OK.

3Click Reset (under Administration menu) to save your configuration.

4Under the Configuration menu, click ETH0, and then click IP.

Note: It is necessary to use the ETH0 port when integrating the KWS600v3 on the local network.

Figure 52 Adm. Page: Configuration/ETH0/IP page

KIRK Wireless Server 600v3 Installation and Configuration Guide