54Installing the KIRK Repeater

Note: The external antenna used for the transmitter is to be fixed-mounted on indoor permanent structures providing a separation distance of at least 20 cm / 8 inches from all persons during normal operation and must not be co-located or operating in conjunction with any other antenna or transmitter. The maximum radiated output power is 1W e.i.r.p. For more information and technical support, please refer to www.polycom.com.

Recording the Installation Information

After completing the installation of the repeaters, record the location of each repeater.

5.2 Checking Indicators

Verify that the repeater LED indicator is continuously on, indicating that the repeater is functional.

5.3Powering the KIRK Repeater

5.3.1Power Options

The power supply for the repeater is 9VDC, 300mA.

5.4 Programming a KIRK Repeater with the KIRK Programming Kit

This section provides information about:

•Content of the KIRK Programming Kit Repeater on page 54

•Set up of the Hardware for Repeater Programming on page 55

•Programming the KIRK Repeater with the ServiceTool on page 55

5.4.1 Content of the KIRK Programming Kit Repeater

The Programming Kit Repeater (Part no. 02319508) consists of:

•splitter

•serial cable

14117800, Ed.2.6

Page 53 Page 55
Page 54
Image 54
Polycom 14117800 manual Checking Indicators, Powering the Kirk Repeater, Power Options
Page 53 Page 55
Top Page Image Contents