Configuring KIRK Wireless Server 600v3 135

Figure 74 Configuration Tool: Alt LDAP Server tab

1In the IP Address area:

Deselect the DHCP check box.

First time you power up the KWS600v3 it acts as a DHCP client. To assign a specific IP address to the unit, it is necessary to disable the DHCP mode.

In the IP Address field, type the IP address of the alternative LDAP Server, provided by your system administrator.

This IP address is now the default address when accessing the alternative LDAP Server.

In the Network Mask field, type the network mask.

In the Default Gateway field, type the IP address of the gateway.

In the Host Name field, type the host name of the KWS600v3.

The host name consist of ip1200- followed by the last three octets of the MAC address of the KWS600v3 (to be found on the label on the rear of the KWS600v3). Eg. ip1200-0f-01-9d

Note: When clicking the Get button, the system provides the host name automatically. The Get button can only be used, if working online and if the IP address is the specific IP address of the KWS600v3 in question and valid on the whole network.

2In the LDAP area:

• In the Primary field, type the IP address of the primary LDAP Server.

3Save the configuration now or wait until you have finished configuring the whole installation.

KIRK Wireless Server 600v3 Installation and Configuration Guide

Page 135
Image 135
Polycom 14117800 manual Configuration Tool Alt Ldap Server tab